LT1013 Dual Precision Operational Amplifier – Datasheet

4,742 views

LT1013 is a Dual precision operational amplifiers, featuring high gain, low supply current, low noise, and low-offset-voltage temperature coefficient. The IC can be operated from a single 5-V power supply; the common-mode input voltage range includes ground, and the output can also swing to within a few millivolts of ground. Crossover distortion is eliminated. The IC comes in an 8 – pin dual in line (DIP) IC packaging.

Precision Operational Amplifier

A Precision operational amplifier is an operational amplifier with better design specifications and topology than the conventional op-amp. Precision Op-amps are more accurate than your average general-purpose op-amps. In terms of design topology, Precision amplifiers have a better precision offset, zero-drift over time, lower internal noise (nV/√Hz), and input bias current. On the component scale, they have precise matching resistors etched in the substrate at the chip level.

For Example; an LM741 op-amp has an offset voltage of 5mV. The offset voltage signifies the voltage that the user has to apply between the +ve and -ve of the IC, in order to get an output of 0V. On configuring the op-amp to operate at a gain of 100. The gain will not only multiply the input signal, but it will also multiply the offset voltage. This will result in the output voltage being off-value by a factor of +/-0.5V. On considering the OP177; a precision op-amp, with an offset voltage of 25uV. The same gain value of 100, would produce an error of only 2.5mV in a signal that has been amplified by a factor of 100.

LT1013 Pinout

LT1013 Pin Configuration

Pin NoPin NameDescription
1OUTPUT AOutput Of Amplifier A
2INV-INPUT AInverting Input Of Amplifier A
3NON-INV-INPUT ANon Inverting Input Of Amplifier A
4V-Negative Power Supply
5NON-INV-INPUT BNon Inverting Input Of Amplifier B
6INV-INPUT BInverting Input Of Amplifier B
7OUTPUT BOutput Of Amplifier B
8V+Positive Power Supply

LT1013 Features

  • Guaranteed Offset Current: 0.8nA Max
  • Guaranteed High Gain
  • Pin Compatible to 1458 and 324 with Precision Specs
  • Guaranteed Offset Voltage: 150μV Max
  • Guaranteed Low Supply Current: 500μA Max
  • Low Voltage Noise, 0.1Hz to 10Hz: 0.55μVp-p
  • Guaranteed Low Drift: 2μV/°C Ma
  • Low Current Noise—Better than 0P-07, 0.07pA/√Hz

Application

  • Battery-Powered Precision Instrumentation
    • Strain Gauge Signal Conditioners
    • Thermocouple Amplifiers
    • Instrumentation Amplifiers
  • 4mA–20mA Current Loop Transmitters
  • Multiple Limit Threshold Detection
  • Active Filters
  • Multiple Gain Blocks

LT1013 Datasheet

You can download this datasheet for LT1013 Dual Precision Operational Amplifier from the link given below:

See Also: LM2904 Low Power Dual Operational Amplifier – Datasheet | LF411 Low Offset Drift JFET Input Op-Amp – Datasheet | LF398 Datasheet Sample and Hold Circuit