29F010 128k 120ns CMOS Flash Memory – Datasheet

1,740 views

The Am29F010 is a 1 Mbit, 5.0 Volt-only Flash memory organized as 131,072 bytes. The Am29F010 is offered in 32-pin PLCC, TSOP, and PDIP packages. The byte data appears on DQ0-DQ7. The device is designed to be programmed in-system with the standard system 5.0 Volt VCC supply. A 12.0-volt VPP is not required for program or erase operations. The device can also, be programmed or erased by standard EPROM programmers.

The standard device offers access times of 45, 55, 70, 90, and 120 ns, allowing high-speed microprocessors to operate without wait states. To eliminate bus contention the device has a separate chip enable (CE#), write enable (WE#) and output-enable (OE) controls. The device requires only a single 5.0-volt power supply for both read and write functions. Internally generated and regulated voltages are provided for the program and erase operations

29F010 Pinout

29F010 Pin Configuration

Pin NoPin NameDescription
1NCNo Connection
2A16 Address Pin 16
3A15Address Pin 15
4A12 Address Pin 12
5A7 Address Pin 7
6A6 Address Pin 6
7A5 Address Pin 5
8A4 Address Pin 4
9A3 Address Pin 3
10A2 Address Pin 2
11A1 Address Pin 1
12A0 Address Pin 0
13DQ 0 Data Output 0
14 DQ 1 Data Output 1
15 DQ 2 Data Output 2
16VSSGround Pin
17 DQ 3 Data Output 3
18 DQ 4 Data Output 4
19 DQ 5 Data Output 5
20 DQ 6 Data Output 6
21 DQ 7 Data Output 7
22CE’Chip Enable Pin
23A10 Address Pin 10
24OE’Output Enable Pin
25A11 Address Pin 11
26A9 Address Pin 9
27A8 Address Pin 8
28A13 Address Pin 13
29A14 Address Pin 14
30NCNo Connection
31WEWrite Enable Pin
32VCCPower Supply

29F010 Key Feature

  • Single power supply operation
    • 5.0 V ± 10% for read, erase, and program operations
    • Simplifies system-level power requirements
  • High performance
    • 45 ns maximum access time
  • Low power consumption
    • 30 mA max active read current
    • 50 mA max program/erase current
    • <25 µA typical standby current
  • Flexible sector architecture
    • Eight uniform sectors
    • Any combination of sectors can be erased
    • Supports full chip erase
  • Sector protection
    • Hardware-based feature that disables/reenables program and erase operations in any combination of sectors
    • Sector protection/unprotection can be implemented using standard PROM programming equipment

You can download this datasheet for 29F010 128k 120ns CMOS Flash Memory – Datasheet from the link given below: